Daily maintenance of the circle making machine

a. Add lubricating oil to the slider, eccentric wheel, pulley, and rotating parts of the circle making machine once a week. Inject lubricating oil into the oil hole every day to keep all parts of the machine lubricated.

b. The mechanic conducts daily inspections according to the equipment inspection and maintenance requirements of the circle making machine, ensuring the normal operation of the sewing machine and keeping records.

c. Regularly check whether the screws and fasteners in each part are locked tightly, and no looseness is allowed; Check whether the power cord is aging or damaged, whether the socket contact is good and reliable, and repair or replace it in a timely manner.

d. Every operator must understand the relevant machine maintenance and upkeep.

e. If the circle making machine is not used for a long time, it should be cleaned first, covered with a protective cover, properly stored, fully lubricated every six months, and idle for a short period of time.

So the above is just a brief introduction to maintenance. The key is that everyone can adhere to the above points when using the looping machine, so the service life of the looping machine will also be longer. In addition to these, we also encounter some problems with circle making machines, and the most important thing is to learn to solve such problems from the source.

Notes:

a. Work without insurance is strictly prohibited! Prohibit two people from operating the same machine at the same time! In work, it is important to concentrate highly and avoid talking to others to avoid distractions.

b. When the circle making machine is turned on, fingers and clothing should be removed from the mold working area to prevent clutch engagement and injury. The machine should not be left empty without riveting.

c. To adjust the machine and troubleshoot, turn off the power. At the end of work, the machine should be cleaned and materials should be properly stored, and the power should be turned off.

d. The mold installation should be tight and reliable, and concentric from top to bottom. The gap between riveting should be adjusted in sequence from the upper mold to the higher point downwards. To prevent damage to the machine due to excessive pressure, the mold must meet quality requirements and have appropriate elasticity with the materials.

So after everyone pays attention to these issues when operating the circle making machine, we actually rarely encounter any problems when using the machine. Everyone should maintain good usage habits, there are still many conveniences.